Set 3 of 3 in the Mechanical Engineering subject series — 61 solved MCQs from the solved mechanical-engineering databank: thermodynamics, boilers, steam, fuels and power-plant basics asked in sub-engineer and lecturer tests, every answer verified against its source key. Questions stay in the same shuffled order for your whole sitting, and a new visit brings a fresh order. You have 61 minutes. If you leave in the middle, your picked answers are saved in your own browser so you can continue where you left off. Tap one option per question, then press Check Answers for your score.
📚 All Mechanical Engineering sets live on the Mechanical Engineering MCQs subject page — finish this set, then move to the next one there.
💪 شاباش! تم صحیح جگہ پر ہو
یہ سوالات PakMcqs کے حل شدہ سوالیہ بینک سے لیے گئے ہیں؛ ہر سوال کا جواب اس کی اپنی key کے علاوہ ایک آزاد قابلِ جانچ حقیقت سے بھی تصدیق شدہ ہے۔
یہ مکمل کر کے Mechanical Engineering MCQs subject page — اس طرح تمہاری تیاری کا بڑا حصہ مکمل ہو جائے گا۔ ہمت رکھو، کامیابی قریب ہے!
In natural circulation type boiler _______________?
Correct answer: heating takes place at bottom and the water supplied at bottom gets converted into the mixture of steam bubbles and hot water which rise to drum.
Duplex feed pumps are used in small steam boilers. These operate on the principle of_________________?
Correct answer: reciprocating pump.
The diameter of internal flue tubes in a Lancashire boiler compared to its shell is_________________?
Correct answer: two-fifth.
Which of the following is steam dbal?
Correct answer: non-coking bituminous coal.
The high pressure boiler is oiie producing steam at a pressure more than_________________?
Correct answer: 75-80 kg/cm2.
The diameter of cylindrical shell of the Lancashire boiler is of the order of__________________?
Correct answer: 1.75 to 2.75 m.
Which of the following is a fire tube boiler________________?
Correct answer: locomotive boiler.
Which of the following substance will have same percentage in both proximate and ultimate analysis___________________?
Correct answer: ash.
Lancashire boiler is of____________________?
Correct answer: all of the above.
Water tube boilers are those in which________________?
Correct answer: work is done during adiabatic expansion.
The lenght of Cornish boiler is of the order of _________________?
Correct answer: 5-7.5 m.
For burning 1 kg of carbon to CO as per chemically correct combusiton, amount of air required is___________________?
Correct answer: 4/3kg.
Which of the following gases has the highest calorific value ________________?
Correct answer: coal gas.
Efficiency of a thermal cycle increases by ________________?
Correct answer: both A. and B..
Alkaline pyrogallate is used in Orsat’s apparatus for absorption of _________________?
Correct answer: 02.
Hygrometery deals with the_________________?
Correct answer: water vapour in air.
The increase in pressure _________________?
Correct answer: raises the boiling point of a liquid.
Equivalent evaporation of water is the evaporation “for a feed water supply at 100°C__________________?
Correct answer: and its corresponding conversion into dry saturated steam at 100°C and 1.033 kg/cm2.
Water boils when its vapour pressure ___________________?
Correct answer: equals that of the surroundings.
The state of vapour under saturation condition is described by_______________?
Correct answer: pressure and dryness fraction.
Heating wet steam at constant temperature is heating it at constant_________________?
Correct answer: pressure.
In an experiment to determine dryness fraction of steam, the mass of water separated was 1.2 kg in 15 mts and the mass of steam passed out in same time was 4.8 kg. Dryness fraction is__________________?
Correct answer: 80%.
At critical point, i.e. p=225.65 kg/cm2, the latent enthalpy of vaporisation is______________?
Correct answer: zero.
Latent heat of dry steam at atmospneric pressure is equal to____________________?
Correct answer: 539 kcal/kg.
In a throttling process_________________?
Correct answer: none of the above.
The dry saturated steam at very high pressure (150-200 kg/cm2) when throttled to atmosphere will become_______________?
Correct answer: wet.
The dry saturated steam at very low pressure, (5-10 kg/cm2) when throttled to atmosphere will become________________?
Correct answer: superheated.
On Mollier chart, free expansion, or throttling process from high pressure to atmosphere is represented by_______________?
Correct answer: horizontal straight line.
A wet vapour can be completely specified by__________________?
Correct answer: pressure and dryness fraction.
The specific heat of superheated steam in kcal/kg is generally of the order of___________________?
Correct answer: 0.5.
One kg of steam sample contains 0.8 kg dry steam; it’s dryness fraction is__________________?
Correct answer: 0.8.
Sublimation region is the region where__________________?
Correct answer: solid and vapour phases are in equi-librium.
The equivalent evaporation of a boiler is a measure to compare _________________?
Correct answer: any type of boilers operating under any conditions.
Equivalent evaporation is the amount of water evaporated in a boiler from and at ____________________?
Correct answer: 100°C.
1 kg.m is equal to_________________?
Correct answer: 9.81 Joules.
Coke is produced by__________________?
Correct answer: strongly heating coal continuously for about 48 hours in the absence of air in a closed vessel.
The critical pressure at which latent heat of vaporisation is zero is________________?
Correct answer: 225.65 kgf/cm2.
For water, at pressures below atmospheric___________________?
Correct answer: melting point rises slightly and boiling point drops markedly.
The saturation temperature of steam with increase in pressure increases____________________?
Correct answer: rapidly first and then slowly.
Superheating of steam is done at_________________?
Correct answer: constant pressure.
Stoichiometric quantity of air is the___________________?
Correct answer: air required for complete combustion of fuel with no excess air.
The coal requirement per kW hour generation in the thermal power plant is of the order of__________________?
Correct answer: 0.6 to 0.8 kg.
The specific volume of steam with increase in pressure decreases_____________________?
Correct answer: rapidly first and then slowly.
If partial pressure of air and steam be pa and ps respectively in a condenser, then according to Dalton’s law, the pressure in condenser is equal to__________________?
Correct answer: Pa+P.
Heating of dry steam above saturation temperature is known as_____________________?
Correct answer: superheating.
Carbonation of coal is the process of________________________?
Correct answer: strongly heating coal continuously for about 48 hours in the absence of air in a closed vessel.
The latent heat of steam at pressures greater than atmospheric in comparison to latent heat at atmospheric pressure is__________________?
Correct answer: less.
At very low temperature, the melting and boiling temperatures become equal. This temperature is____________________?
Correct answer: 273.16°K.
Pick up false statement?
Correct answer: In quality governing, quantity of fuel is varied to suit the load and total charge of air is varied.
Pick up the wrong statement?
Correct answer: aluminium in steel results in excessive grain growth.
Density of water is maximum at__________________?
Correct answer: 4°C.
The specific weight of water is 1000 kg/m”_________________?
Correct answer: all the above.
For very great pressures, viscosity of moss gases and liquids__________________?
Correct answer: shows erratic behavior.
Piezometer is used to measure_____________________?
Correct answer: very low pressures.
Center of pressure compared to e.g. is___________________?
Correct answer: below it.
The centre of gravity of the volume of the liquid displaced by an immersed body is called ___________________?
Correct answer: centre of buoyancy.
The pressure in the air space above an oil (sp. gr. 0.8) surface in a tank is 0.1 kg/cm”. The pressure at 2.5 m below the oil surface will be __________________?
Correct answer: 3 metres of water column.
In an immersed body, centre of pressure is __________________?
Correct answer: below be centre of gravity.
Two dimensional flow occurs when________________?
Correct answer: the fluid particles move in plane or parallel planes and the streamline pat-terns are identical in each plane.
Uniform flow occurs when_____________________?
Correct answer: the magnitude and direction of the velocity do not change from point to point in the fluid.
Two pipe systems can be said to be equivalent, when the following quantities are same__________________?
Correct answer: friction loss and flow.
Finished this set? 📚 All Mechanical Engineering sets · 🧠 Quiz Hub — all subjects & services
Comments ()
💬 Post a comment